View Single Post
Old 02-24-2015, 10:33 PM   #9
Tom Wesenberg
Senior Member
 
Tom Wesenberg's Avatar
 
Join Date: May 2010
Location: Mpls, MN
Posts: 27,582
Default Re: flywheel starter ring gear access

I used some large flat washers and a length of 1/2" threaded rod to take my clutch pack apart. One of the discs has a chisel mark in the tooth, and this disc has teeth a hair wider than the others. This disc goes on the end of the stack which faces the rear of the car. In other words, it the one closest to the tranny, and moves the least when the clutch pedal is pushed.
Tom Wesenberg is offline   Reply With Quote