Thread
:
Milling the head
View Single Post
07-31-2018, 10:56 AM
#
4
Jim Brierley
Senior Member
Join Date: Jun 2010
Location: Temecula, CA
Posts: 4,085
Re: Milling the head
Not much! Stock pistons protrude above the block some, more if the block has been surfaced. You need a minimum of .030" of clearance between the piston and the head because the rods stretch when running, more so at high RPM.
Jim Brierley
View Public Profile
Send a private message to Jim Brierley
Find More Posts by Jim Brierley