[walkerlakeprinter]

I have a used metal header cover that needs help. Photo one shows how it lines up along the front of the header. The second photo shows the driver's side end and it seems to fit ok. The third photo shows how it is twisted at the passenger end. The fourth photo shows how the lip is above the wood, as contrasted to how it fits ok in the fifth photo.


Where to begin?? The old header did not have the metal cover and the car had a sheet metal roof that was simply bent down in the front to meet the visor. I'm not looking for anything close to fine points.....just wanting to get a roof that will keep the rain out in the rare times we get rain here in the high desert.