View Single Post
Old 09-30-2021, 10:53 AM   #7
PC/SR
Senior Member
 
Join Date: May 2010
Location: Santa Rosa, CA
Posts: 1,276
Default Re: Potential for manifold warping?

The two left most bolts can be taken off and on with the manifold in place. Have done it occasionally to adjust lifters. Use a half inch 15 degree box wrench, and fingers. It is awkward fit but can be done. Of course the second time is easier than the first which is one reason for the trial fit. Try it, You can always remove the manifolds if you have to. Assuming you have a stock manifold as mentioned above.
PC/SR is offline   Reply With Quote