The Ford Barn - View Single Post

updraught · 10-09-2019, 10:45 PM

The bell shaped cover at the bottom has to fit the stick. If you grind too much off there it will flop around. A good platter can build up the pits with copper plate and grind it down.

10-09-2019, 10:45 PM	#4
updraught Senior Member Join Date: Feb 2015 Location: Australia Posts: 1,971	Re: Replating Gear Shift Lever The bell shaped cover at the bottom has to fit the stick. If you grind too much off there it will flop around. A good platter can build up the pits with copper plate and grind it down.