View Single Post
Old 09-17-2019, 08:39 PM   #2
Chuck Sea/Tac
Senior Member
 
Chuck Sea/Tac's Avatar
 
Join Date: May 2010
Location: Between Seattle & Tacoma
Posts: 2,351
Default Re: Sticking Starter Switch

Was the rod stuck down? Then it’s binding. If the rod was loose, then the copper strip it pushes down to contact the round copper button below was “welded” together. Take it apart and file the contact area down. Pay attention to the orientation of the insulating washers ect. There’s one that goes into the hole to keep the copper bolt from grounding out against the case.
Chuck Sea/Tac is offline   Reply With Quote
Sponsored Links (Register now to hide all advertisements)