Quote:
Originally Posted by rockfla
Kevin
I will try to slide by this morning and run a quick voltage test. I assume you probe the two wires coming out of the generator? I will try and post pictures and should be around lunch time today EST (USA). I see we are 14 hours difference mate!!! Timing doesn't work for either of our schedules
|
I did explain to you where to connect the voltmeter. The black wire to ground at the cutout mounting screw would be good. The red wire to one of the cut out terminal screws but make it at the Ä terminal. Set your meter as I explained earlier to VOLTS DC. Rev up engine to a steady setting for 30 seconds or so and you should be reading about 7.2 to 7.5 volts. Make sure your meter connections are good. Regards, Kevin.