Re: Move Pinion forward and back per Les Andrews
I'm putting this out there to see if I understand the procedures.
1. Carrier pre-load. Assemble and install carrier, no spider or axles, bolt up both axle housings. Add spacers under carrier bearing races in axle housings until carrier won't turn. (Is it ever necessary to shim the races?)
2. Bolt up banjo and right axle housing and set in carrier. Add minimum of two .010 gaskets, then bolt up left axle housing, maybe more gaskets, until carrier turns snugly, making sure I never bind up or distort the axle housings.
3. Now divide the gaskets 1/2 on each side and proceed to pinion and ring gear pattern and backlash. Always keeping the same gasket stack and locating the gaskets to either side as required to achieve proper wear pattern and backlash.
Please correct me or confirm I got it right.
Thank you Tom and Jim for your time and patience.
Al
|