View Single Post
Old 09-26-2019, 01:20 PM   #10
BRENT in 10-uh-C
Senior Member
 
BRENT in 10-uh-C's Avatar
 
Join Date: May 2010
Location: Eastern Tennessee
Posts: 9,022
Default Re: Holes drilled in dipper tray

Quote:
Originally Posted by Patrick L. View Post
I'm not a big fan of the holes in the low point of the dipper troughs,[ bottom pic ] When sitting the oil will drain leaving the rod bearings to run dry for the time it takes for the oil pump to fill them. Its the dry running of bearings I'm not a fan of. Those 4 holes I'd braze.


I guess I am missing it. Which one has holes at the bottom of the well that would cause the oil to leak out?





.
.
__________________
.

BRENT in 10-uh-C
.
www.model-a-ford.com
...(...Finally Updated!! )

.
BRENT in 10-uh-C is offline   Reply With Quote