deuce lover,
Humm from the snout? There only fine threads for the cap to screw on the snout. I brought home a stout puller from a friend and need to see if it will fit/ work. It is heavy and made for pulling hubs.
Have done some checking on tires. I kind of like the look of the Firestone 6.00-20. I looked at the Lucas too. They might be fine, They look a little more like a rounder car tire??
Tire, tubes, and flap availability is a issue.
Some pictures requested by David of the drivers side of the "B" engine:
Also the rad cap is about 3.5 inches in dia I dont see any markings under the cap but it is very dirty. Lots of dents!
The rust:
(repeat picture) Lower passangers door:
Rear inboard area at spare well.
Regards,
Chris