View Single Post
Old 07-01-2020, 11:44 AM   #4
Jim Brierley
Senior Member
 
Join Date: Jun 2010
Location: Temecula, CA
Posts: 4,085
Default Re: G28T center cam bearing oiling?

Sponsored Links (Register now to hide all advertisements)
In this case too much oil is better than not enough, although there must have been some oil to that brg. from the factory. There doesn't happen to be holes in the block above the brg. that would allow gravity to oil them, from splash?
Jim Brierley is offline   Reply With Quote