The Ford Barn - View Single Post - y-block blow by..

Hot Rod Reverend · 11-18-2019, 04:47 PM

Ok, so there is not a pan made from 1960 on that was specifically for PCV? lol now I am confused. I have the pan that dmsfrr shows (from a 1957 Ford) but I installed the PCV plumbing that Kultulz shows in both pictures above (albeit one has the crazy bend in the oil spout for a radiator overflow tank and the other one is straight). Is not the pan on the right in Kultulz's post the same pan as the one that dmsfrr pictures?

dmsfrr - did not know that the T bird pans had an oil spout 1/5" shorter, but it surely makes sense.

11-18-2019, 04:47 PM	#57
Hot Rod Reverend Senior Member Join Date: May 2010 Location: Lancaster, CA Posts: 917	Re: y-block blow by.. Ok, so there is not a pan made from 1960 on that was specifically for PCV? lol now I am confused. I have the pan that dmsfrr shows (from a 1957 Ford) but I installed the PCV plumbing that Kultulz shows in both pictures above (albeit one has the crazy bend in the oil spout for a radiator overflow tank and the other one is straight). Is not the pan on the right in Kultulz's post the same pan as the one that dmsfrr pictures? dmsfrr - did not know that the T bird pans had an oil spout 1/5" shorter, but it surely makes sense. __________________ Lancaster, California Visit hotrodreverend.com to view hundreds of pictures and videos of the build of the 1955 Ford Club Sedan!