Quote:
Originally Posted by 1930 coupe
There are two different gear assemblies or turtles. Yours should have a round hole with a slot, and the bottom end of your cable should have a round end with a tab. Check to see if it will go in the gear assembly properly. The other 30-31 type has a square hole, Make sure you have the correct gear assembly, a 28-29 cable will not go in a 30-31 gear assembly.
|
I have the right gear assembly for a 29 and it was working just fine and then just stopped. The cable is not broken and the speedometer works when tested. I had the rear in the air with the car running and the cable off the speedometer. It was not turning but when i pressed the inner cable in about 1'8'' with my finger it started to spin. people talk about adding a nail to the gear but when I try to place a fine finishing nail in I cannot even feel a hole.
Ron