Thread: Convertible top for a 1953 Mercury
View Single Post
Old 07-17-2020, 06:38 PM   #18
Merc Cruzer
Senior Member
 
Merc Cruzer's Avatar
 
Join Date: Jul 2010
Location: Conifer, Colorado
Posts: 2,429
Default Re: Convertible top for a 1953 Mercury
I now have all the information I need to duplicate the "piece" in question. It is 2 1/4" high by 40 9/16" wide, and is made out of 16 gauge steel. The first hole is 3/8" on center, to the top and left edge. 13 screws, each 3 1/2" on center from the other. #10 3/4" sheet metal screws.

Trip to DenCol to pick up the piece, drill the holes and install, after I get I get a new taking strip to put in the valley on the left, where this mounts.

Not sure if anyone is still following this, but if you are, now you have the answer.
Attached Images
File Type: jpg DSCN0052.jpg (56.7 KB, 7 views)
File Type: jpg 20200718_103852 -1.jpg (57.2 KB, 5 views)
File Type: jpg 20200718_103913 - 1.jpg (47.2 KB, 5 views)
Last edited by Merc Cruzer; 07-26-2020 at 12:42 PM.
Merc Cruzer is offline   Reply With Quote