The Ford Barn - View Single Post - Torque plate blueprint, or possibly rent one?

steve hackel · 04-06-2018, 09:22 PM

I appreciate all the suggestions & directions, but I do not have any cylinder heads to either bore one out for a torque plate or even use one for a pattern, so I am out there asking for a blueprint to make one. Just a side bar question, if I find a single cylinder head (left or right) would that one head work for both sides as a boring / torque plate or do I need left & right examples? I guess I could search Craigs list around here for one.

04-06-2018, 09:22 PM	#7
steve hackel Senior Member Join Date: May 2010 Location: midlothian illinois Posts: 447	Re: Torque plate blueprint, or possibly rent one? I appreciate all the suggestions & directions, but I do not have any cylinder heads to either bore one out for a torque plate or even use one for a pattern, so I am out there asking for a blueprint to make one. Just a side bar question, if I find a single cylinder head (left or right) would that one head work for both sides as a boring / torque plate or do I need left & right examples? I guess I could search Craigs list around here for one.