The Ford Barn - View Single Post - 1934 Tudor needs a little hop-up

Tinker · 06-29-2020, 02:57 AM

16" 6.00 is correct. A little bigger tire will add some.3:54 is a good gear set for the rear with a strong engine. If three sp is important and is fine. I'd next look at the motor. How is that doing? Milling heads will add some compression and remain in the stock zone. Stocker should run in the 55-60 mph range no issue.

06-29-2020, 02:57 AM	#2
Tinker Senior Member Join Date: May 2010 Location: MN Posts: 7,053	Re: 1934 Tudor needs a little hop-up 16" 6.00 is correct. A little bigger tire will add some.3:54 is a good gear set for the rear with a strong engine. If three sp is important and is fine. I'd next look at the motor. How is that doing? Milling heads will add some compression and remain in the stock zone. Stocker should run in the 55-60 mph range no issue.