[George/Maine]

I don't know why you put the meter in the high tension hole better stick our finger in there. LOL

Try this test.
Once you see spark then get the point working.
At the high point of lobe that's were the air gap is .015 get a feeler gauge.

Here is a simple way to check coil and condener.
Put power to coil make sure there are no broken strands end of wire.
Remove points wire at coil
Now put a condenser on coil lug terminal wire end.
Take coil wire out of cap and hold 1/4 to grd.
leave other end in coil.
Get a piece of wire grd one end and touch conderser.
When you make contact and remove should see spark.
Turn key on.