The Ford Barn - View Single Post - Trouble shifting into 2nd or 3rd- BUT.. Unique situation

marty in Ohio · 10-09-2018, 01:48 PM

I had the same problem. It turns out that the 1/2 inch round ball on the bottom of the shifter was actually a 1/2 inch square cube. A Model A friend welded the cube round again and ground it to 1/2 inch. Now it shifts like new.
Marty

10-09-2018, 01:48 PM	#8
marty in Ohio Senior Member Join Date: May 2011 Location: Elyria, Ohio Posts: 756	Re: Trouble shifting into 2nd or 3rd- BUT.. Unique situation I had the same problem. It turns out that the 1/2 inch round ball on the bottom of the shifter was actually a 1/2 inch square cube. A Model A friend welded the cube round again and ground it to 1/2 inch. Now it shifts like new. Marty