The Ford Barn - View Single Post

glennpm · 10-07-2019, 06:33 PM

Hi David,

Shimming may work. I haven't seen a good picture of the gouge and how far back on the pan it is. If you think 1/8" at the groove would work, you need to add quite a bit more under the front motor mount. The amount of increase is controlled by a line from the front to the rear mounts. You may have to loosen or shim the rear mounts too.

10-07-2019, 06:33 PM	#47
glennpm Senior Member Join Date: Sep 2014 Location: Wiscasset, Maine Posts: 2,018	Re: 36 Ford drag link orientation question Hi David, Shimming may work. I haven't seen a good picture of the gouge and how far back on the pan it is. If you think 1/8" at the groove would work, you need to add quite a bit more under the front motor mount. The amount of increase is controlled by a line from the front to the rear mounts. You may have to loosen or shim the rear mounts too.