Quote:
Originally Posted by rbassemir
Thanks guys for the quick response and information.
I am going to order a horn relay and run one wire to each horn. This solves a second problem. The hole in the bolt holding the bracket to the fender was too small to get the two horn wires through.
Now I just need to trace the wiring to figure out which wires to use and where to mount the relay in a convenient location. My wiring is so old and dirty it is impossible to tell their colors. Time to pull out the ohm meter to trace the wires.
Thanks again for the quick feedback.
Rich
|
Sounds like it is time for a new wire harness.