View Single Post
Old 12-07-2018, 09:39 AM   #13
BRENT in 10-uh-C
Senior Member
 
BRENT in 10-uh-C's Avatar
 
Join Date: May 2010
Location: Eastern Tennessee
Posts: 11,486
Default Re: Weld and grind roller tracks

Quote:
Originally Posted by Ruth View Post
Hope your grinding them to the correct measurement or it is not going to do you much good.



This is very true, ...AND if you go by the measurement in Les Andrew's book, it is incorrect when compared to the Ford print. When you use the centering tool to check on the shoes being in the proper location, this becomes very evident.
__________________
.

BRENT in 10-uh-C
.
www.model-a-ford.com
...(...Finally Updated!! )

.
BRENT in 10-uh-C is offline   Reply With Quote