Quote:
Originally Posted by pinball73
Kohnke did not check for twisted or bent rod, generally they all looked the same, laid out flat, but that is about as far as I went there. as for wrist pin clearance, the machine shop took care of all that I presume when they put in the new wrist pin bushings, they are supposed to be good & I trust them!
|
You can't tell by looking at rods and see if there out of alignment, they have to be put on a Rod Aligner, to check for twist, bend, and off set.
As far as wrist pins go, any movement that can be felt, is no good. The clearance should be right on at .005.
Hope you find the problem.
Herm.