The Ford Barn - View Single Post - Simple to make and use Toe-In gauge

Bruce of MN · 12-11-2020, 05:32 AM

You could make something like that out of plywood and make sure the arms were long enough to match the radius of the spot where toe-in is measured.

Edit: I mean the tool in post #4

12-11-2020, 05:32 AM	#5
Bruce of MN Senior Member Join Date: May 2010 Location: VA Posts: 1,412	Re: Simple to make and use Toe-In gauge You could make something like that out of plywood and make sure the arms were long enough to match the radius of the spot where toe-in is measured. Edit: I mean the tool in post #4 Last edited by Bruce of MN; 12-11-2020 at 05:20 PM.