[QUOTE=Y-Blockhead;1952022][FONT="Comic Sans MS"][SIZE="3"][COLOR="DarkGreen"]Just curious. When you spray copper cote on your gasket what do you do about the overhang of the gasket due to the 5.5 head being physically smaller than a stock head/head gasket? I suppose you could mask it off?
Not that much of it that shows and it hasn't been an issue to me.
Quote:
Originally Posted by Werner
Guten Abend lieber Dave.
If you retighten the Z-head screws repeatedly, do you only use the same torque or do you loosen every single screw a little beforehand?
Your copper spray irritates me. We have copper spray as assembly grease (it doesn't dry) or copper lacquer (it doesn't slide).
|
I don't loosen them first. Others do.
Brent, perhaps I will install my next head without using the copper coat.