The Ford Barn - View Single Post - Four-Ways Work, Turn Signals Don't !!!

Herb Concord Ca · 09-12-2020, 07:02 PM

First 6 ohms is too high, are you sure they are 6 ohms? You should use two 1 ohm resistors, one for the right side and one for the left. Best if they are installed in the wires going to the front flashers, the resistors are wired from these wires to ground.

09-12-2020, 07:02 PM	#3
Herb Concord Ca Senior Member Join Date: May 2010 Location: Concord CA Posts: 637	Re: Four-Ways Work, Turn Signals Don't !!! First 6 ohms is too high, are you sure they are 6 ohms? You should use two 1 ohm resistors, one for the right side and one for the left. Best if they are installed in the wires going to the front flashers, the resistors are wired from these wires to ground.