Quote:
Originally Posted by Jim Brierley
Both articles by Tom and Les are very good. I do have a disagreement with Les when his book says to bolt both axle housing halves together to get a preliminary pre-load check. (or words to that effect). Bolting the halves together without shims (gaskets) can bend the housings and result in leaks. I recommend bolting the left housing on,(I use only 4 bolts at this ( time) place the assembly on end and slip the right side on. Now measure the gap between the housing and the center section. This will tell you how many gaskets to use. Now install half that thickness on both sides and check backlash. This is time consuming but worth the effort. Just my opinion!
|
Yes, and that process can ruin cups and cones if squeezed too hard. They end up looking like a pinion bearing that had the preload set with a rattle wrench.