Re: 1955 Ford Club Sedan Refresh Blog
One way to remove the suspension bushes without a press is to get a piece of pipe approx. 2 to 3 inches long that is slightly larger in diameter than the bush. Get a large heavy washer to sit on the end of the pipe and place them on one side of the bush.
On the other side of the bush you use a socket slightly smaller than the dia. of the bush, put a length of threaded rod through the lot with a nut each end and start winding one of the nuts.
As you tighten the nuts the socket will push the bush out of the A arm into the pipe on the other side.
To install the new bushes you reverse the process.
|