View Single Post
Old 12-07-2014, 05:38 PM   #168
DavidG
Senior Member
 
DavidG's Avatar
 
Join Date: May 2010
Posts: 6,284
Default Re: 1933 can't start after recent restart

In re-reading your last note, I'm not sure that you had removed the insulators or just the bolts that pass through the insulators. You will not create enough space to rotate the front motor mount bracket sufficiently without removing the insulators from the front cross member. If you leave them in place and try to jack up the front of the engine to achieve the needed clearance you will have jacked it up too far and you will run the risk of permanent damage to the rear motor/transmission mount.
DavidG is offline   Reply With Quote