View Single Post
Old 08-21-2015, 08:14 AM   #22
Senior Member
jerseyboy's Avatar
Join Date: May 2010
Location: Northwest CT
Posts: 494
Default Re: Truck based woody


If you notice, the area between the wheel wells is sheet metal. The piece consists of five parts; the two wells, two side sections, and a center section. All the pieces are spot welded at flanges, except the wells, that are spot welded on the main surface. The wood floors consist of a front frame made of maple and oak and two floor boards inside the frame, made of 11/16 thick 5 ply plywood. The rear sections on either side of the wheel wells/floor pan, are maple floor boards running perpendicular to the frame and fastened to the frame and pan.

Keep V-8ing and 4-banging!
She just don't have the appetite
For gas somehow,
And Dad, I got four carburetors
Hooked up on it now.
I tried to hook another
To see if I'd do a little good,
But ain't no place to put it
'Less I perforate the hood.

Wanted, lower side sections of 32 radiator cowl.
jerseyboy is offline   Reply With Quote
Sponsored Links (Register now to hide all advertisements)