View Single Post
Old 05-09-2019, 05:42 PM   #2
BRENT in 10-uh-C
Senior Member
BRENT in 10-uh-C's Avatar
Join Date: May 2010
Location: Eastern Tennessee
Posts: 8,991
Default Re: Steering column bracket

Originally Posted by vern hodgson View Post
How was the steering column bracket installed? Looks as though it was soldered and riveted to the tank! So the only holes would be the four rivet holes?

That is correct. The solder was used to seal the plate in case of weeping. The issue I find is most of the ones that are weeping have cracks radiating out from the rivet holes where the metal is fatigued. The correct way to repair it is to weld the cracks and the holes solid and re-drill. That way the steering column is rigid again. Lots of vibrations are transferred thru the column.

BRENT in 10-uh-C
...(...Finally Updated!! )

BRENT in 10-uh-C is offline   Reply With Quote
Sponsored Links (Register now to hide all advertisements)