View Single Post
Old 03-17-2019, 01:05 PM   #16
40 Deluxe
Senior Member
 
Join Date: May 2010
Location: now Kuna, Idaho
Posts: 3,000
Default Re: Snyderís 6:1 head

Quote:
Originally Posted by Killerbee View Post
I did run a level across it and the block didnít see anything out of the ordinary but thatís with the naked eye. You shouldnít have to machine a new head flat. I was going to go with the 5.5.1 but for the same price I went with the 6:1 now Iím regretting it. Snyderís will be getting a call again Monday.
A basic rule is to never assume anything. Measure it! After the first gasket blew your troubleshooting should have included a trip to a machine shop to have the head checked with a machinist's straight edge. A carpenter's level won't cut it!
How about the block surface? Have you verified that it is true? Again, you can't just assume.
40 Deluxe is offline   Reply With Quote