View Single Post
Old 03-17-2019, 12:19 PM   #14
Killerbee
Member
 
Killerbee's Avatar
 
Join Date: Mar 2014
Location: South jersey
Posts: 40
Default Re: SnyderÂ’s 6:1 head

Well I’m over it and too many other people have had the same issue. I shouldn’t have to resurface a new head. I would expect that from a swap meet head not a new one. Everything was properly prepped torqued warmed cooled retorqued with the same issue. The gasket seems to blow on different spots every time either it’ll leak coolant into the cylinder or blow exhaust out of the side obviously there is an issues with this head. I’m not doing it a fourth time.
Killerbee is offline   Reply With Quote