Re: My new project 1928 Ford!!!!!
Here are a few pictures of what I did this past weekend. Also had the front axle drilled and now waiting for the front finned drums to get done to install. I am not the best welder in town but so far I am doing OK more practice will help. You are not looking at a dent on the passenger door panel just where the panel curves to meet the door frame brace. I had to cut the lower corner of the rear section on both side to be able to fit the side panels. After I have these panels installed and welded in place I will do another pie cut to reinstall these corner pieces.
Thanks
Frenchy
Last edited by frenchy dehoux; 09-04-2012 at 08:18 PM.
|