The Ford Barn - View Single Post

Mart · 12-17-2019, 02:17 PM

Hi guys. how do you remove a valve seat assuming it can't be set up in a milling machine?

Can it be shrunk by welding on it? Can you weld on it? (I have MIG).

I do have a hand powered valve seat cutter but don't fancy trying to cut them out with that.

Any advice or pointers offered appreciated.

Mart.

12-17-2019, 02:17 PM	#1
Mart Senior Member Join Date: May 2010 Location: Solihull, England. Posts: 8,744	Valve seats. How to remove? Hi guys. how do you remove a valve seat assuming it can't be set up in a milling machine? Can it be shrunk by welding on it? Can you weld on it? (I have MIG). I do have a hand powered valve seat cutter but don't fancy trying to cut them out with that. Any advice or pointers offered appreciated. Mart.