The Ford Barn - View Single Post

Tom Wesenberg · 11-16-2018, 08:27 AM

The front shaft is held in a straight line by the crankshaft bearing and front tranny case bearing. The output shaft is held in a straight line by the pocket bearing and rear tranny case bearing. Depending on the time period, the output shaft has a built in lip, or a separate spacer for the pocket bearing (transmission main shaft pilot bearing).

11-16-2018, 08:27 AM	#2
Tom Wesenberg Senior Member Join Date: May 2010 Location: Mpls, MN Posts: 27,582	Re: Main Shaft in Trans is worn... The front shaft is held in a straight line by the crankshaft bearing and front tranny case bearing. The output shaft is held in a straight line by the pocket bearing and rear tranny case bearing. Depending on the time period, the output shaft has a built in lip, or a separate spacer for the pocket bearing (transmission main shaft pilot bearing).