Re: Fender welting
Easiest way to think of it is that the welting lines up with and just below the vertical front edge of the door/back edge of the cowl. It goes where the two pieces of the splash apron bolt together. Lower end abuts to the front inner corner of the running board, and the top end of the welt goes up under the body. So you'll need to make cuts in the welting at the bottom and top curves for a good fit. The top curve is pretty tight, so you'll need to make some relief cuts to take out a couple small pie-shaped pieces.
The curved area you're referring to between the splash apron "nose" and the fender is spot-welded without any welting.
|