The Ford Barn - View Single Post

California Charlie · 10-10-2018, 10:27 PM

Is there a difference in the Radius Rod Ball Cap Bolts? The new bolt set that I have allows the bolts to sink too deep into the bottom of the Bell Housing. The cross shaft that keeps the bolts from turning isn't captured by the groove in the head of the bolt. The bolts are too low.

Do I have an older generation Bell Housing or is my problem with the new bolts that don't appear to fit? Is there a remedy for this?

10-10-2018, 10:27 PM	#1
California Charlie Senior Member Join Date: May 2010 Posts: 157	Radius Rod Ball Cap Bolts Is there a difference in the Radius Rod Ball Cap Bolts? The new bolt set that I have allows the bolts to sink too deep into the bottom of the Bell Housing. The cross shaft that keeps the bolts from turning isn't captured by the groove in the head of the bolt. The bolts are too low. Do I have an older generation Bell Housing or is my problem with the new bolts that don't appear to fit? Is there a remedy for this?