Re: Rod Clearance
Usually on a stroke that big some lower bore relief is needed. I use a plastic Ty-rap to check clearances the ones I have measure a bit more than the .070 When I can get the Ty-rap in between the rod and bore I stop grinding I like to see at least .100
Ronnieroadster
__________________
I use the F word a lot no not that word these words Flathead , Focus and Finish.
"Life Member of the Bonneville 200 MPH Club using a Ford Flathead block"
Owner , Builder, Driver of the First Ford Flathead bodied roadster to run 200 MPH Record July 13, 2018 LTA timing association 200.921 in one and a half miles burning gasoline.
First ever gas burning Ford flathead powered roadster to run 200 MPH at Bonneville Salt Flats setting the record August 7th 2021 at 205.744 MPH
|