Quote:
Originally Posted by JM 35 Sedan
Chris, I'll look for pictures I've taken in the past or take some new ones for you. This is a thick piece of rectangular bar stock, radiused on ends to sit firmly on the exposed back area of the bearing race, and just a tad bit less in total length than the inside diameter of the housing where bar locates. This method works very well for me. I can have these pressed out and new pressed in before I could get my mig welder set up and weld one of these, and as said earlier, I save these races for possible reuse it they pass my inspection. I've also found some other uses for these, so don't care to mess them up by doing the welding method of removal. Will post pics and give you dimensions asap. Stay tuned ......
|
Thanks for the picture - makes it very easy to see what you described. I like this method as most folks don't have the KR Wilson pullers that were originally used by many.