The Ford Barn - View Single Post

flatheadmurre · 09-13-2019, 11:34 AM

If i remember right the geometry of the bolts sticking out at an angle don´t let you mont them both to the pumps first...they won´t go into the holes in the frame even if they are slotted...one side you can have attached to the pump but not both...
Sadly MAC´s quality control is between bad to none nowdays so anything is possible...and when you call them even when you know other people have had the same issue...std answer is sold a lot and never had any complaints...
I wouldn´t modify them...if they haven´t got spacing and thread right what says they got the rubber part good...

09-13-2019, 11:34 AM	#7
flatheadmurre Senior Member Join Date: Apr 2015 Location: Sweden Posts: 3,045	Re: 53 Ranchwagon flathead motor mounts If i remember right the geometry of the bolts sticking out at an angle don´t let you mont them both to the pumps first...they won´t go into the holes in the frame even if they are slotted...one side you can have attached to the pump but not both... Sadly MAC´s quality control is between bad to none nowdays so anything is possible...and when you call them even when you know other people have had the same issue...std answer is sold a lot and never had any complaints... I wouldn´t modify them...if they haven´t got spacing and thread right what says they got the rubber part good...