The Ford Barn - View Single Post - Tattersfield manifold with dual Strombergs

vincent · 02-19-2021, 08:55 AM

Engine rebuild is almost finished and I will fit a high rise dual carb Tattersfield manifold. On the old engine I ran a 97 Stromberg (9510A) with standard jetting.
The new engine is a french flathead with 4,2 ltrs, nothing special inside except a lightened flywheel. Should I leave the jetting well alone or is a change neccessary?
Thanks for your advice!
Harty

02-19-2021, 08:55 AM	#1
vincent Senior Member Join Date: Jun 2020 Location: Germany Posts: 204	Tattersfield manifold with dual Strombergs Engine rebuild is almost finished and I will fit a high rise dual carb Tattersfield manifold. On the old engine I ran a 97 Stromberg (9510A) with standard jetting. The new engine is a french flathead with 4,2 ltrs, nothing special inside except a lightened flywheel. Should I leave the jetting well alone or is a change neccessary? Thanks for your advice! Harty