Thread: Stan's 34 Ford
View Single Post
Old 08-14-2020, 11:26 AM   #16
STAN WHITE
Senior Member
 
Join Date: Dec 2019
Location: Gardnerville, Nevada
Posts: 185
Default Re: Stan's 34 Ford

Ed Bingly would cut a piece out of the end exhaust ports. This would allow him to open up the restricted area. Then he would weld it back together, If you look closely you can see the welds. I never knew anyone else that did this. He also advanced the Cam so many degrees. His porting job was a work of art. More info on Ed go to Bings speed Shop in Santa Rosa, Cal. Stan
STAN WHITE is offline   Reply With Quote