The Ford Barn - View Single Post

expavr · 05-25-2019, 01:24 AM

I had backing plates powder coated and the finish has so far resisted DOT 3. On a cautionary note the powder coating material flowed into a few of the bolt holes reducing them in size which had to be drilled out to accept the bolts. Could be a problem with the wheel cylinders.

05-25-2019, 01:24 AM	#4
expavr Senior Member Join Date: May 2010 Location: Hansville, WA Posts: 776	Re: Finish for wheel cylinders I had backing plates powder coated and the finish has so far resisted DOT 3. On a cautionary note the powder coating material flowed into a few of the bolt holes reducing them in size which had to be drilled out to accept the bolts. Could be a problem with the wheel cylinders.