View Single Post
Old 02-23-2011, 07:50 AM   #12
John Kennedy
Senior Member
 
John Kennedy's Avatar
 
Join Date: May 2010
Location: Tucson Arizona
Posts: 301
Default Re: Fleathead Engine Stands

I converted a cheap-o 3 leg stand into a wide base 4 leg stand, and built the engine holder out of 1/4" plate drilled to bolt onto the exhaust ports. The plate is welded to a thick angle-cut tube that rotates in the stand.
Actually patterned after a HAMB post I found.
I can take pictures and post em up, if you'd like.

John
__________________
Building a 29 Sedan on 32 chassis........ very slowly....
John Kennedy is offline   Reply With Quote