The Ford Barn - View Single Post

Kurt in NJ · 01-09-2018, 08:37 PM

so most likely they are ,010 undersaized
is it just 1 bearing at the mains or are there several in a row (how wide are the inserts)
what is the size of the bore in the block
what is the size of the crankshaft
can you take pictures and post them

to look them up you need the sizes---block bore, crankshaft, width ---there are some charts of bearings that were "made to work"

01-09-2018, 08:37 PM	#2
Kurt in NJ Senior Member Join Date: May 2010 Location: on the Littlefield Posts: 6,158	Re: bearing insert identification help... so most likely they are ,010 undersaized is it just 1 bearing at the mains or are there several in a row (how wide are the inserts) what is the size of the bore in the block what is the size of the crankshaft can you take pictures and post them to look them up you need the sizes---block bore, crankshaft, width ---there are some charts of bearings that were "made to work"