Re: 1941 Ford Pickup frame-off restore for the next generation
Got the Booth almost completed, (done) hoping to lay some paint down this weekend. Kinda hard to show the size, basically 12' x 8'.
Picked up my 2K Epoxy, gun, sandpaper and ready to paint.
Did some rust treating with KBS RustBlast, like it much better than Ospho. Seemed to work a lot faster.
Underside of running board was wire brushed, degreased, Rustblast treated, scrubbed during this time with scotchbrite pad for 1 hour. Rustblast wiped off, than rinsed with water. Compressed air dried. 2K epoxy sealer applied with gravity feed gun.
High build primer applied 3 coats
Got my work cut out for me for the next few winter months. LOL
Last edited by mrfliboy; 01-25-2016 at 08:59 AM.
|