The Ford Barn - View Single Post

Bob C · 12-12-2017, 08:46 PM

I just was looking at the factory service manual and noticed the keyway on the crank for the cam gear is about 180 from the keyway for the pulley. Didn't know that.
looking at your picture you need to turn the crank about 180 to see the cam gear keyway.

Bob

12-12-2017, 08:46 PM	#84
Bob C Senior Member Join Date: May 2010 Location: So Cal Posts: 8,749	Re: Rebuilt Flathead Problems. I just was looking at the factory service manual and noticed the keyway on the crank for the cam gear is about 180 from the keyway for the pulley. Didn't know that. looking at your picture you need to turn the crank about 180 to see the cam gear keyway. Bob Last edited by Bob C; 12-12-2017 at 08:52 PM.