The Ford Barn - View Single Post

GordonC · 12-12-2017, 11:21 AM

I will be trying some of the suggestions today. Going to pull the intake to get a look at where the valves are when this is sitting with dots aligned on cam and crank gears. Also going to see if I can find the original cam bolts and keeper to install. I know I have them somewhere. I will give each of the cylinders a couple squirts of mystery oil when I get ready to attempt to fire it again. I will be back later today with what I find.

12-12-2017, 11:21 AM	#44
GordonC Senior Member Join Date: May 2010 Posts: 201	Re: Rebuilt Flathead Problems. I will be trying some of the suggestions today. Going to pull the intake to get a look at where the valves are when this is sitting with dots aligned on cam and crank gears. Also going to see if I can find the original cam bolts and keeper to install. I know I have them somewhere. I will give each of the cylinders a couple squirts of mystery oil when I get ready to attempt to fire it again. I will be back later today with what I find.