View Single Post
Old 02-15-2020, 08:35 PM   #16
Bill Cilker
Senior Member
 
Bill Cilker's Avatar
 
Join Date: Apr 2011
Location: Milpitas, CA
Posts: 268
Default Re: So when would my car actually have been made?

John
Here is what I did to look at my frame number. I took the nuts off of all the bolts for the body and fenders on the left hand side of the car. Including the hood hooks and the hood stop. Then I very carefully jacked up the body and fender about 1" in the cowl area. With the floor boards out, I was able to wire brush the top of the frame, from the inside and see my frame number. I my case it did match the engine number.
__________________
Bill Cilker, Jr
Unrestored 190A
45B, 160B & 189A
Bill Cilker is offline   Reply With Quote