View Single Post
Old 11-30-2019, 11:45 AM   #1
DC 69
Member
 
Join Date: Jan 2016
Location: Monterey Bay, Ca
Posts: 35
Default Generator Brush Adjustment

Good morning,

From the description in the Les Andrews book, I believe I have a 30/31 generator (photo of end plate w/brushes attached).

Was driving one day and noticed my ammeter was registering 0 amps. I've done most of the work on my '29 CCPU, but I was intimidated by the thought of taking the generator apart to see if there was an obvious reason for the 0 amp reading. I followed the instructions in the book and my fears were gone (not as complicated as I thought).

The problem was one of the brush screws came out and the wire was disconnected. I easily re-connected the brush & wire and started it right up, but now the ammeter is reading 20 amps wth RPMS increased (all lights off).

Question: Which is the 3rd brush? Is it adjustable? If so, how?

Any help is greatly appreciated. Thanks
Attached Images
File Type: jpg Generator Brushes (768x1024).jpg (59.6 KB, 49 views)
DC 69 is offline   Reply With Quote